Advertisement
First Screen displayed after pushing Configure?
Once selection made and the knob is pushed, next screen:
Push knob, next screen:
Sub Proc. Out to
Satellite Spkr
Push knob to go back to the main menu.
With the mixer output (sound source) connected to the subwoofer, all of the system adjustments will be made
using the RBN Sub DSP module. The User processing choices as in the RBN™112, such as the 9 band GEQ, will
not be used, the RBN™112
should be in Flat mode.
The hi-pass filter on the RBN™112 is unchanged from it's full range setting, because the Sub performs the cross-
over functions.
Program EQ: Displays current EQ selection (Flat preset is the default on 1st time power up)
(Presets) EDM, Voice, Rock, DJ .......
The program EQ selection is applied to the Graphic Equalizer and Bass enhancer.
"Custom" is displayed if GEQ has been adjusted by the user.
The last preset used, including a Custom one, is what will load the next time the RBN™ Sub is
powered up.
Delay:
Current delay time
Adjust screen 0 to 150 msec also Feet and Meters
Graphic EQ: Current settings 9 Bands +/- 12 dB at ISO octave centers (63Hz to 16 kHz)
Press the encoder to enter the screen to adjust the GEQ. Turning the encoder selects the frequen
cy band to be adjusted. Press the encoder to adjust that band. Pressing the encoder again returns
to the band select mode. To exit to the main menu, turn the encoder past the 16 kHz band to the
X and Exit will appear. Press the encoder to exit.
RBN™ Sub Polarity:
Normal (Default Selection)
Inverted
Temperature: The temperature of the amplifier is monitored and display as long as it is in a safe operating range.
If the temperature gets too high, it goes into protect mode which is displayed here and on the
main Input Level screen.
Front LED:
Set front baffle LED operation to:
Crossover Sub to
Proc. Out:110 Hz
Rotate knob to select a different crossover frequency
110 Hz is the default selection, other choices are 100 Hz and 120 Hz.
Connect Mixer to:
Sub input.
Advertisement
