Advertisement
Enclosure Materials & Finish:
Black polyurethane painted enclosure with 18 mm Baltic Birch plywood, with a full-length, black powder
coated perforated steel grille.
Dimensions (H x W x D)
In use position:
29.84 in. x 22.07 in. x 24.75 in. (not including wheels, 4.06" deep)
758 mm x 561 mm x 629 mm
In transport position:
28.81in. x 22.07 in. x 29.84 in.
732 mm x 561 mm x 758 mm
Net Weight:
106 Lbs.
Mounting Provisions:
1 3/8" pole mount with M20 threaded pole for stand mounting a suitable speaker on top of the Sub, and
four large rubber feet on bottom for floor use.
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Electronic input impedance (nominal):
Balanced inputs: 10 k ohms line level sensitivity selected.
Unbalanced input: 5 k ohms, line level sensitivity selected.
Mic switch sensitivity Increase: 26 dB
Input Sensitivity for Full Output (Level full CW): 0.23 V RMS
(Switch in LINE position)
Input Overload Point (Switch in LINE position): +14 dBV
Status Indicators: Front baffle LED is blue for power ON indication, and turns
tion.
Rear panel LCD screen in Input Level mode, shows DDT activation by flashing "DDT" on the LCD screen, right
hand side. Signal level indicated by bar graph coming from left hand side of LCD.
DSP Section Specifications:
Latency: Approx. 2.7 msec
ADC and DAC Sampling frequency: 96 kHz
Bit Depth: 24 bits for ADC/DAC, 32 bits for DSP calculations.
Infrasonic filter protection: 36 dB/octave roll-off
Nominal amplifier frequency response: +0, -1 dB from 10 Hz to 30 kHz
Hum and noise: Greater than 90 dB below rated power
DDT dynamic range: Greater than 14 dB
THD and IM: Typically less than 0.1 %
(48.3 kg)
red to indicate DDT activa-
Advertisement
