Stihl FS 130 Instruction Manual page 29

Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
FS 130, FS 130 R
Mounting Metal Cutting Attachment
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Check direction of rotation of cutting
attachment
Cutting attachments with 3 or
4 blades (1, 3) may point in either
direction – these cutting attachments
must be turned over regularly to help
avoid one-sided wear.
The cutting edges of cutting
attachments 2, 4 and 5 must point
clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
Place the cutting attachment (6) on
N
the thrust plate (7).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
Fit the thrust washer (8) – convex
N
side must face up.
Fit the rider plate (9).
N
Block the shaft (10).
N
Use the combination wrench (12) to
N
screw the mounting nut (11) on to
the output shaft counterclockwise
and tighten it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
English
27