Adjusting The Throttle Cable; Fitting The Carrying Ring; Mounting The Deflector - Stihl FS 130 Instruction Manual

English

Adjusting the Throttle Cable

A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
2
Press down the throttle trigger
N
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
24

Fitting the Carrying Ring

The carrying ring comes standard with
the machine or is available as a special
accessory.
For position of carrying ring see "Main
Parts".
Place the clamp (1) against the
N
drive tube with the tapped hole on
the left (viewed from engine).
1
Squeeze the two ends of the clamp
N
together and hold in that position.
Insert the M6x14 screw (2).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
1
1
2

Mounting the Deflector

Mounting the Deflector
1
3
2
3
1 Deflector for mowing attachments
2 Deflector for mowing heads
Deflectors (1) and (2) are both mounted
to the gearbox in the same way.
Place the deflector on the gearbox
N
flange.
Insert the screws (3) and tighten
N
them down firmly.
FS 130, FS 130 R