Stihl FS 130 Instruction Manual page 23

Pull out the wing screw – the
N
washer (6) remains on the wing
screw.
Separate the clamp moldings – the
N
springs (4 and 5) remain in the
lower clamp.
Securing the Handlebar
7
Place the handlebar (7) in the lower
N
clamp (1) so that distance A is no
more than 6 in (15 cm).
Place the upper clamp in position
N
and hold both clamp moldings
together.
Push the wing screw through the
N
two clamps as far as stop – hold all
parts together and secure them.
FS 130, FS 130 R
A
1
Place the secured assembly on the
N
handle support (8) with the wing
screw at the side nearest the
engine.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Line up the handlebar at a right
N
angle to the drive tube – check
distance A again.
Tighten down the wing screw firmly.
N
8
Mounting the Control Handle
Take out the screw (9) – the nut (10)
N
remains in the control handle (11).
Push the control handle onto the
N
end of the handlebar (7) until the
holes (13) line up – the throttle
trigger (12) must point towards the
gearhead.
Insert the screw (9) and tighten it
N
down firmly.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
English
21