IDEAL Logic HEAT 12 User Manual
Hide thumbs
Also See for Logic HEAT 12:
- Installation and servicing (72 pages) ,
- User manual (8 pages) ,
- Pocket manual (73 pages)
Advertisement
USER gUiDE
Logic HEAT
12 15 18 24 30
For Installation Guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
For the very latest copy of literature for specification and maintenance practices visit our
website www.idealboilers.com where you can download the relevant information in PDF format.
For alternative languages in our User Guides please visit our website www.idealboilers.com.
Advertisement
Related Manuals for IDEAL Logic HEAT 12
Summary of Contents for IDEAL Logic HEAT 12
- Page 1 Do not use reconditioned or copy parts that have not been clearly authorised by Ideal. For the very latest copy of literature for specification and maintenance practices visit our website www.idealboilers.com where you can download the relevant information in PDF format.
-
Page 2: Table Of Contents
Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal Boilers is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency. -
Page 3: Boiler Operation
If the boiler still fails to start Operation. consult a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII). MAinS PoWeR off To remove all power to the boiler the mains power switch must be turned off. Ideal Logic Heat - User’s... -
Page 4: Condensate Drain
(A) to maximum, (Must return to original setting once cold spell is over). Place the heating on continuous and turn the room thermostat down to 15ºC overnight or when unoccupied. (Return to normal after cold spell). Ideal Logic Heat - User’s... -
Page 5: Points For The Boiler User
The boiler is operating in frost protection. foR Any qUeRieS PleASe RinG tHe ideAl ConSUMeR HelPline : 01482 498660 note. boileR ReStARt PRoCedURe - To restart boiler, turn mode knob to “restart” position and immediately turn knob back to required setting. -
Page 6: Fault Codes
Check system pressure is between 1 & 1.5bar on the pressure gauge (if fitted Flow Temperature Overheat to a sealed system). If the boiler fails to operate then please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of Unconfigured PCB the warranty period.