Wired Lan Settings - Panasonic AJ-PX800G Operating Instructions Manual

r SSID connection destination list screen
1 Selection status
A checkmark [l] is displayed on the currently selected SSID. (This does not show the connection status).
2 SSID
The SSID list registered in the detected SSID and the connection history is displayed. SSIDs are displayed in order from the one with the strongest
signal.
3 Whether there is connection history
[H] is displayed in the SSID that has a past connection history. SSID with past connection histories are displayed even if the camera is outside the
service area.
4 Encryption format
This is the encryption method used by the access point.
5 Radio wave strength
This shows the signal strength of the access point.
[4G/LTE] mode
Use the following procedure when you connect the camera with the 4G/LTE USB modem.
Select [4G/LTE] in the main menu → [NETWORK SETUP] → [NETWORK SEL].
1
2
Check the network connection.
Check whether to connect the camera to the network with 4G/LTE.
When network connection is made properly, the network status icon at the upper right of the thumbnail screen changes in yellow, and applications
(FTP client function) which require network can be used.
@
NOTE
t The startup time after turning on the power may be longer due to starting of the network.
t When you change the settings of [NETWORK SEL], the changes will not be relected until the camera is restarted. After the settings have been
changed, the setting screen termination may take time due to the restart of the network service.

Wired LAN settings

The settings to connect to computers using the wired LAN are as follows.
Set each item in the main menu → [NETWORK SETUP] → [LAN PROPERTY] as necessary.
1
[DHCP] and [DHCP SERVER] are mutually exclusive.
[MAC ADDRESS]: MAC address of wired LAN (cannot be changed)
[DHCP]: Setting whether to use automatic acquisition via DHCP ([ENABLE]: Use automatic acquisition/[DISABLE]: Does not use automatic
acquisition (Factory setting: [ENABLE])
[IP ADDRESS]: IP address (Factory setting: [192.168.0.1])
[SUBNET MASK]: Subnet mask (Factory setting: [255.255.255.0])
[DEFAULT GATEWAY]: Default gateway (Factory setting: [192.168.0.254])
[PRIMARY DNS]: Primary DNS server setting (Factory setting: [0.0.0.0])
[SECONDARY DNS]: Secondary DNS server setting (Factory setting: [0.0.0.0])
[DHCP SERVER]: Setting whether to use the DHCP SERVER function ([ENABLE]: Uses the DHCP SERVER function/[DISABLE]: Does not use
the DHCP SERVER function) (Factory setting: [DISABLE])
Select [LAN] in the main menu → [NETWORK SETUP] → [NETWORK SEL].
2
3
Configure the settings of wired LAN of your computer.
(For Windows)
Display [Properties] in [Internet Protocol Version 4 (TCP/IPv4)] and conigure the settings. For details on how to display the screen, refer to [Start] →
[Help and Support].
f When [DHCP SERVER] is set to [ENABLE] on the camera
Select [Obtain an IP address automatically] and [Obtain DNS server address automatically] in the [General] tab. Select [Automatic private IP
address] in the [Alternate Coniguration] tab.
f When [DHCP SERVER] is set to [DISABLE] on the camera
Select [Use the following IP address] in the [General] tab.
- [IP address]: Enter the same address as that of the camera.
Chapter 10 Network Connection — Network settings
1 2
– 180 –
3 4 5