Shot Mark; Text Memo - Panasonic AJ-PX800G Operating Instructions Manual

1
Add text memos to images to be changed.
For details on adding text memos, refer to "Text memo recording function" (page 70).
Select [TEXT MEMO CLIPS] in the main menu → [CLIP] → [REPOSITION] and display the thumbnails of clips with text memos.
2
3
Move the cursor over the clip where you want to change the thumbnail and press the <SET> button, and then move the cursor to
the text memo display on the lower row.
4
Select the thumbnail to be replaced from the text memos, place the cursor on it, and select [EXCH. THUMBNAIL] in the main
menu → [CLIP]. (Fig. 1)
5
Press the <SET> button, and select [YES] using the cursor buttons on the confirmation screen that is displayed.
The menu closes and the thumbnail for the clip is replaced. (Fig. 2)
@
NOTE
t You can view the thumbnail position (number of frames from the top of the clip) from the [THUMBNAIL] item of the clip information display. Since
thumbnails usually come from the top of the clip, 0 is displayed.
t Even if you change the thumbnail, playback from the thumbnail screen will still start from the beginning of the clip.
t The thumbnail image with the [!] mark may be displayed for clips of a format with a different number of lines and frequencies when displaying a text
memo clip without displaying the thumbnail of the text memo position displayed at the bottom section.

Shot mark

Shot marks can be added to a clip thumbnail to distinguish the clip from other clips.
You must assign [SHOT MARK] to the USER button beforehand. For details, refer to "Assigning functions to USER buttons" (page 60).
1
Use the cursor buttons to move the cursor over the clip to which you want to add a shot mark.
2
Press the USER button to which [SHOT MARK] is assigned.
f A shot mark is added to the thumbnail of the clip at the cursor position.
f To delete a shot mark, place the cursor on the clip again and press the USER button to which [SHOT MARK] is assigned.
@
NOTE
t You can attach a shot mark during recording.
t Add shot marks after recording stops to attach the shot mark to the most recently recorded clip.
For details, refer to "Shot mark recording function" (page 70).
t When adding a shot mark to or deleting the shot mark from a clip recorded across multiple P2 cards, do this with all these P2 cards inserted into card
slots.

Text memo

You can add text memos during recording or playback. Text memos can be used to play clips at some point or break clips into chunks and copy the
necessary portions.
Adding the text memo
You must assign [TEXT MEMO] to the USER button beforehand. For details, refer to "Assigning functions to USER buttons" (page 60).
1
Press the USER button to which [TEXT MEMO] is assigned while recording, playback, thumbnails.
f Pressing this button while recording or playing back adds a text memo at the instance when the button was pressed. At this time, [TEXT MEMO]
(when successful) or [TEXT MEMO INVALID] (when unsuccessful) is displayed.
f Pressing this button while the thumbnail screen is displayed inserts a text memo in the clip thumbnail (normally at the beginning) position.
@
NOTE
t Up to 100 text memos can be recorded to a single clip.
t Playback may stop for a moment when the USER button to which [TEXT MEMO] is assigned is pressed. This is not a malfunction.
Chapter 5 Playback — Thumbnail operations
Fig. 1
– 104 –
Fig. 2