Removing And Installing Bracket For Additional Atf Filter And Additional Atf Cooler - Audi A8 2003 Workshop Manual

10.5 Removing and installing bracket for ad‐
ditional ATF filter and additional ATF
cooler
Removing
– Remove the three bolts -6-.
– Remove bolts with washers -5-.
– Remove the four bolts -3-.
– Remove additional ATF cooler -A- (hoses remain connected).
– Detach bracket -B-.
Note
When renewing bracket first remove additional ATF filter and ad‐
ditional ATF cooler from bracket.
Installing
Installation is carried out in reverse sequence; note the following:
Note
Rubber buffers are fitted to the three attachment points at top of
bracket. Before installing, check they are seated correctly and re‐
new if necessary.
Tightening torques
Component
Bracket -B- to body -D-
3 x bolt -6- with washer -5-
Additional ATF cooler -A- to bracket -B-
4 x bolt -3-
multitronic 01J, front-wheel drive - Edition 11.2007
Nm
10
5
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
10. Servicing ATF cooling system on vehicles with 3.0 ltr. MPI engine
Audi A8 2003 ➤
81