Maintaining Your Opener; Care Of Your Opener; Operation Of Your Opener; Specification - Chamberlain HandyLift Deluxe CR650EVO Installation And Operating Instructions Manual

OPERATION OF YOUR OPENER

Your opener can be activated by any of the following
devices:
• Opener Control Panel: UP & DOWN buttons
• Remote Control Transmitter: hold the button down
until the door starts to move.
• The Outside keyswitch or keyless
entry system (if you have installed any of these
accessories).
When the opener is activated:
• If open, the door will close. If closed, the door will open.
• If closing, the door will stop.
• If opening, the door will stop (allowing space for entry
and exit of pets and for fresh air).
• If the door has been stopped in a partially open or
closed position, it will reverse direction.
Obstruction behaviour:
• If an obstruction is encountered while closing, the door
will reverse.
• If an obstruction is encountered while opening, the door
will reverse and stop.
• The optional Protector System™ uses an invisible beam
which, when broken by an obstruction, causes a closing
door to open and prevents an open door from closing. It
is STRONGLY RECOMMENDED for homeowners with
young children.
Opening the door manually:
Door should be fully closed if possible.
Weak or broken springs could allow an
open door to fall rapidly. Property damage
or serious personal injury could result.
The door can be opened manually by pulling the
release cord down firmly.
To re-engage the door, pull the release cord down firmly.
The opener light will turn on:
• when opener is initially plugged in;
• when the power is briefly interrupted;
• when the opener is activated.
• when IR Beams are triggered with the door in the
Open position.
(the light turns off automatically after 2-1/2 minutes.)
SPECIAL NOTE: Chamberlain strongly recommends that the Protector System
MAINTENANCE AND CARE OF YOUR OPENER

CARE OF YOUR OPENER

When properly installed, your opener will operate
with minimal maintenance. The opener does not
require additional lubrication.
Limit and Force Settings: These settings must be
checked and properly set when the opener is
installed. Weather conditions may cause some
minor changes in the door operation, requiring
some re-adjustments, particularly during the first
year of operation. Refer to limit and force setting in,
section 13.
Follow the instructions carefully and repeat the
safety reverse test after any adjustment.
Transmitter: Additional
purchased at any time. Refer to Accessories. Any
new transmitters must be programmed into the
opener.
Transmitter battery:
decreases, replace the battery.
MAINTENANCE OF YOUR OPENER
Once a Month:
• Repeat safety reverse test.
Make any necessary adjustments
(section 13).
• Manually operate door. If it is unbalanced or
binding, call for professional garage door
service.
• Check to be sure door opens and closes fully.
Set limits and/or force if necessary.
SPECIFICATIONS HANDYLIFT PLUS CR650EVO
Input Voltage:
Rated Load:
Max.Pull Force:
Max. door weight:
Max. lift under spring tension: 20kg
Max. door area:
Standby Power:
Drive:
Max. Drum Rotations:
Memory Registers:
Operating Frequency:
TM
be installed on all garage door openers.
11
transmitters can
If transmission range
230-240 VAC, 50 Hz, 110 W
25 Nm
500 N @ O300 mm
80 kg
2
16.0 m
<1 Watt
DC gearmotor permanent
lubrication
4 1/ 2
64
433.30/433.92/434.54 MHz
be