Setting The Heating Control - Danfoss Eco Installation Manual

User Guide
3.
1 flashes, indicating automatic daylight saving
time is on. Use
confirm.
Note: Default is set at Daylight Saving ON

5.3 Setting the Heating Control

1.
If the display is off, press
to open the funtction menu. Press
again to open the advance menu.Use
select , press
3.
1 flashes, indicating moderate heating re-
sponse is selected (recommended for district
heating). Use
confirm.
Note: Default setting is dependant on the code number - please see table in chapter 1.1
24 06/2015
to shift to 0, press
, then press both
to confirm.
to shift to 0, press
eco Intelligent Radiator Thermostat
4.
0 flashes, indicating automatic daylight saving
time is off. Press
to
2.
Use to select
to
4.
0 flashes, indicating quick heating response is
selected (recommended for all boilers), press
to to confirm.
VIJPD102
to confirm.
, press to confirm.
Danfoss Heating Solutions