Printing Out Network Setting Information - Canon PRO-100S series Online Manual

Printing Out Network Setting Information

You can print out the current network settings of the printer.
Important
• This print out contains valuable information about your computer. Handle it with care.
1. Make sure that the printer is turned on.
2. Load a sheet of A4 or Letter-sized plain paper.
3. Press and hold the RESUME/CANCEL button, then release the button when the POWER
lamp flashes 6 times.
The printer starts printing the network setting information.
The following information on the printer's network setting is printed out.
Item
Wireless LAN
Connection
MAC Address
SSID
Communication Mode
Channel *1
Encryption
WEP Key Length
Authentication
Signal Strength
TCP/IP Version
IPv4 IP Address
IPv4 Default Gateway
Subnet Mask
IPv6 IP Address *2
IPv6 Default Gateway *2 Default Gateway (IPv6)
Subnet Prefix Length *2 Subnet Prefix Length
IPsec *3
Explanations of the item
Wireless LAN
Connection status
MAC Address
SSID
Communication Mode
Channel
Method of the Encryption
WEP Key Length
Method of the Authentication
Signal Strength
TCP/IP Version
Selected IP Address (IPv4)
Default Gateway (IPv4)
Subnet Mask
Selected IP Address (IPv6)
IPsec setting
192
Setting
Enable/Disable
Active/Inactive
XX:XX:XX:XX:XX:XX
SSID of the wireless LAN
Infrastructure
XX (1 to 13)
none/WEP/TKIP/AES
Inactive/128/64
none/auto/open/shared/WPA-PSK/WPA2-PSK
0 to 100 [%]
IPv4 & IPv6/IPv4
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX
XXXX:XXXX:XXXX:XXXX
XXXX:XXXX:XXXX:XXXX
XXXX:XXXX:XXXX:XXXX
XXXX:XXXX:XXXX:XXXX
XXX
Active