Table of Contents
Advertisement
R
R R
E. Fire Safety
To provide reasonable fire safety, the following should be
given serious consideration:
• Install at least one smoke detector on each floor of your
home.
• Locate smoke detector away from the heating appliance
and close to the sleeping areas.
• Follow the smoke detector manufacturer's placement and
installation instructions and maintain regularly.
• Conveniently locate a Class A fire extinguisher to contend
with small fires.
•
In the event of a hopper fire:
• Evacute the house immediately.
• Notify fire department.
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Do NOT Overfire.
Or any such action that may cause a fire hazard.
January 28, 2010
F. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
Reciprocating Saw
Hammer
Phillips Screw driver
Tape Measure
Plumb Line
Level
Framing Material
Hi-temp Caulking Material
Gloves
G. Inspect Appliance & Components and
Pre-Use Check List
Place the appliance in a location near the
1.
final installation area and follow the proce-
dures below:
Open the appliance and remove all the parts
2.
and articles packed inside the Component
Pack. Inspect all the parts and glass for ship-
ping damage. Contact your dealer if any irregu-
larities are noticed.
.
All safety warnings have been read and fol-
lowed.
This Owner's Manual has been read.
4.
Floor protection requirements have been met.
5.
Venting is properly installed.
6.
The proper clearances from the appliance and
7.
chimney to combustible materials have been
met.
The masonry chimney is inspected by a profes-
8.
sional and is clean, or the factory built metal
chimney is installed according to the manufac-
turer's instructions and clearances.
The chimney meets the required minimum
9.
height.
All labels have been removed from the glass
10.
door.
Plated surfaces have been wiped clean, if
11.
applicable.
Thermostat or remote has been installed.
12.
1.
A power outlet is available nearby.
A good quality surge protection is highly recom-
14.
mended to protect the electronics.
250-7251H
Castile Pellet Insert
Safety Glasses
Framing Square
Electric Drill & Bits (1/4")
1/4" Self-Tapping Screws
May also need:
Vent Support Straps
Venting Paint
Page 7
Advertisement
Table of Contents
