Table of Contents
Advertisement
Castile Pellet Insert
7
Appliance Set-Up
A. Reversible Top or Rear Flue Adapter
Top Vent Installation
1. Release ammo can latches on each side. Figure 18.1.
. Place the reversible adapter in the correct position for your
installation.
. Make sure BOTH latches are in position before securing
them.
Rear Vent Installation
o
1. Remove the 90
adapter and installation screws from the
packaging.
o
2. Attach the 90
adapter onto the vent adapter, using the
screws provided. You will need to pre-drill the holes for screw
placement. Be sure to adjust the 90
position for venting before drilling.
. Silicone the pipe joints according to the Note below.
NOTE: All pipe must be sealed using welded
seam pipe whenever possible. Seal pipe joints
with high temperature silicone, minimum rate of
F (60
C).
0
0
500
Ammo Can Latches
Figure 18.1 - Top Vent
Figure 18.2 - Rear Vent
Page 18
o
adapter to the desired
screw
Figure 18.3 - Rear Vent
250-7251H
B. Leveling System
The back legs are adjustable to allow for customized fit
into zero clearance boxes.
1. Loosen top screws and remove bottom screws.
. Adjust leg to desired height. Leg can slide up (shorter)
or down (longer) to level the insert.
. Tighten top screws.
4. Drill holes for the bottom screws and re-install
screws. Figure 18.5.
Loosen top screws and remove
bottom . Adjust leg to desired height.
Figure 18.4
Drill holes and
re-install bottom
Figure 18.5
screws
January 28, 2010
R
Advertisement
Table of Contents
