Ext Input; Demo Mode - JVC KD-LX100 Instructions Manual

I
20
To select the external component to use
- EXT INPUT
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adaptor KS-U57 (not supplied)
To use the external component as the playback
source through this unit, you need to select
which component - CD changer or external
component -to use When shipped from the
factory, "CHANGER" is selected as the external
component
. CHANGER To use the CD changer
. LINE INPUT: To use the external
component other than the CD
changer
To make the front panel look flat (hiding
the control panel)
- FLAT PANEL
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat When shipped from the
factory, "FLAT OFF" is selected
. FLAT ON
The control panel will not
come out when you turn on
the unit
l
FLAT OFF
Note
To use the control panel,
press I- v so that the
control panel comes out If no
operation is done for about
10 seconds, it automatically
goes back into the receiver
You can use the control panel
normally
When "FLAT ON" is selected, you can eject a CD bv
holding I44
V
To turn the demo mode on or off
- DEMO MODE
You can turn the demo mode on or off When
shipped from the factory, "DEMO ON" is
selected
l
DEMOON Turns the demo mode on
The demonstration will start
automatically if no sound
comes in for 3 minutes
l
DEMOOFF
Turns the demo mode off
Note:
rf the unit has been reset (and the power is on),
demonstration will start ifno sound comes in for
about IO seconds
Controlling the volume
automaticallv (Audio Cruise)
You can select the proper cruise mode for your
car
This unit changes the volume level automatically
(at 3 possible levels) based on the driving speed
of your car by detecting the alternator's
generating frequency (Audio Cruise)
If you want to use this mode, follow the
procedure below When shipped from the factory,
this mode is set to "CRUISE OFF"
l
CRUISE 1 Select this if your car is
relatively quiet
l
CRUlSE2: Select this if your car is
relatively loud
The volume increase rate is
twice as much as that of the
CRUISE 1 setting
l
CRUISE OFF Cancels Audio Cruise
I
2
3
Press and hold SEL (Select) for
more than 2 seconds so that one of
the PSM items appears on the
display. (See page 18.)
Select "CRUISE MODE."
Select the desired setting.
As you turn the control dial, the Audio
Cruise mode changes as follows