Carpet Cleaning - Bissell OXYPOWER PRIME 93R4 SERIES User Manual

Operations
Fill the tank
1. Remove the solution tank by lifting it straight
up, then away from the lower body.
2. Unscrew the black cap at the bottom of the
solution tank.
3. Fill with hand hot (60°C/140°F MAX)
tap water to the WATER line. Fill the rest
of the tank with BISSELL 2X Formula to
the FORMULA line. Replace and tighten
the black cap. NOTE: Do not boil or microwave
water as it can damage the solution tank.
4. Place solution tank on lower body.

Carpet cleaning

1. Set ReadyTools dial to "FLOOR CLEANING".
2. Plug into proper outlet.
3. Turn the power switch to the ON (I) position
(located on the back of unit)
4. With foot, press the red recline lever (located
on the back of unit).
5. Cleaning Strokes. While pressing the spray
trigger, make one slow forward wet pass and
another one back. Caution: Do not overwet.
6. Release the spray trigger and make one
slow forward and backward pass over the
same area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. Empty the collection tank when dirty water
reaches the full line, or when the solution tank is
empty.
WARNING
To reduce the risk of fire and electric shock due to internal
component damage, use only BISSELL cleaning fluids
intended for use with the deep cleaner. Non-BISSELL
cleaning solutions may harm the machine and void
the guarantee.
1.
3.
1.
CAUTION
Take care not to run over loose objects or edges of
area rugs. Stalling the brush may result in premature
belt failure.
ATTENTION
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary
vacuum or deep cleaner may aggravate this condition.
www.BISSELL.com
2.
4.
3. & 4.
Power
Recline
Lever
7