Troubleshooting - Bissell OXYPOWER PRIME 93R4 SERIES User Manual

Troubleshooting

Problem
Reduced
spray OR
no spray in
upright mode
Reduced
spray OR
no spray in
attachment
Deep cleaner
not picking
up solution
Please do
not return
this product
to the store.
www.BISSELL.com
12
Possible causes
Solution tank empty
Lint screen on solution tank cap
clogged
Solution tank empty
Spray nozzle clogged
Pump needs priming
Machine is reclined
ReadyTools dial is set to "FLOOR
CLEANING"
Collection tank not aligned/
secured
Collection tank full
Removable nozzle installed
improperly
Removable nozzle full of debris
Red lint screen under collection
tank clogged
ReadyTools dial not set properly
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Refill tank with water and formula
Soak solution tank cap in warm water
and then rinse under running water
Refill tank with water and formula
Clean spray nozzle by rinsing
tool under water
Place tool on floor and press
spray trigger
Return machine to full upright
position until it locks into place
Choose "TOOLS" setting on
ReadyTools dial
Check tank alignment and secure
with side latches
Empty tank
Unplug unit. Align four "hooks" on
nozzle into bottom first, then snap
into place on top
Unplug unit. Remove nozzle and
rinse under running water
Remove debris from lint screen
Choose either "FLOOR CLEANING"
or "TOOLS" for desired cleaning
method