Samsung SRN-470D User Manual page 71

Camera event
You can set whether to react to camera events (motion detection, video analysis, audio events) and alarm
output / time.
[menu]  ▼  <event>  ►  <Camera event>  [enTer]  ▲▼◄►  [enTer]
• Mode : Select whether to react to camera events or not.
• Alarm Out : Sets the alarm output method.
For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 62)
`
• Alarm Duration : Sets the duration of alarm signal and alarm sound.
• Camera MD : You can set motion detection for the camera connected.
- Motion Detection : Select the motion detection mode for the camera connected to each channel.
The NVR generates alarm output only when the connected network camera is configured to detect events and an actual
`
M
event is detected.
video Loss detection
You can set the camera so that the camera can trigger the alarm if it is disconnected or the video is lost due to
unstable network connection.
[menu]  ▼  <event>  ►  <video Loss detection>  [enTer]  ▲▼◄►  [enTer]
• Video Loss State : Specify the use of video loss detection.
• Alarm Out : Select an alarm output method.
For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 62)
`
• Alarm Duration : Specify the duration of the alarm output with the beep.
English _71