Samsung SRN-470D User Manual page 63

• Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specified alarm
output port.
• Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified
alarm output port.
• Duration : Sets the alarm duration for the alarm signal and beep sound.
- Check Alarm, Replace Alarm signals will output through the selected alarm out ports (1, 2, 3, and 4).
SRN-470D supports only alarms : <1> and <2>.
`
- If <Beep> was selected, a beep will sound.
- If <All> was selected, both beep sound and alarm signal through rear side ports will output.
<Check> status means that the HDD is operating but it has problems that require technical examination.
`
M
( ) appears on the Live screen.
<Replace> status means that the HDD has defect and requires immediate replacement.
`
( ) appears on the Live screen.
remote devices
You can specify the ID of a remote control that will operate in sync with NVR.
[menu]  ▼  <device>  ►▼  <remote devices>  [enTer]  ▲▼◄►  [enTer]
• Remote Control : Specify the use of the remote control.
• ID : Select an ID number to synchronize with the remote control.
If it does not match with the remote control ID, the remote control will not operate at all.
For changing the remote control's ID, refer to "Changing the Remote Control ID". (Page 13)
`
M
English _63