Day And Time Announcements - AT&T E5908 User Manual

16
Press CLOCK
1.
The system will announce the cur-
rent clock setting, then announces
"To set the clock, press
CLOCK."
Press CLOCK
2.
The system will announce the cur-
rent day setting, then announces
"To change the day, press SKIP
or REPEAT, to change the hour,
press CLOCK."
Press
3.
SKIP
or
REPEAT
until the system announces the cor-
rect day, then press CLOCK.
Press
4. SKIP
or
REPEAT
until the system announces the cor-
rect hour, then press CLOCK.
Press
5. SKIP
or
REPEAT
until the system announces the cor-
rect minutes, then press CLOCK.
Press
6.
SKIP
or
REPEAT
until the system announces the cor-
rect year, then press CLOCK. The
system announces the current clock
setting.
Answering System Operation

Day and time announcements

To set day and time
Before playing each message, the answering system
announces the day and time the message was received.
Before using the answering system, follow the steps at
left to set the day and time, so messages are dated cor-
rectly. If the clock is not set, before playing messages, the
system will prompt "Time and date not set" each time.
The system uses voice prompts to guide you. Each time
you press or
SKIP
or year increases or decreases by one. When you hear
the correct setting, press
setting.
To check day and time
You can press
CLOCK
day and time without changing it.
NOTE: You can press and hold
increase or decrease the minute or year by ten.
NOTE: Caller ID provides the time and date. Set the year so that the
day of the week can be calculated from the Caller ID information. After you
set the time once, it will thereafter be set automatically with incoming Caller
ID information. The time will be set automatically only if you subscribe to
Caller ID service provided by your local telephone company (see page 5).
37 37
, the day, hour, minute
REPEAT
to move to the next
CLOCK
at any time to hear the current
or
REPEAT to
SKIP