Wiring Diagram - United States Stove Company 1602M Installation And Operator's Manual

Wood or coal gravity style (up-flow) supplemental furnace

Table of Contents

All electrical connections should be done by

a qualiﬁ ed electrician.

NOTE: The extra brown wire on the fan

center has no use. It should be capped off or

The conduit may be cut shorter to provide a

cleaner installation

FIREBOX BRICK REPLACEMENT

This furnace comes from the factory with the ﬁ rebrick in-

stalled. However, if brick replacement is necessary, fol-

low these instructions. Before furnace operation, remove

the brick retaining strip. This piece is used during ship-

ping to reduce brick damage.

There are 6 full brick and 1 half brick per side. Install the

half brick ﬁ rst by putting the bottom of the brick in ﬁ rst

and let it rest against the ﬁ rebox side and ﬁ re grates.

Then slide it to the rear. After that, install the #2, #3, #4,

#5 & #6 brick, sliding the 6th brick forward to allow for the

7th brick. Repeat for opposite side.

NOTE: Prior to operation, be sure to remove the brick

retaining strips.

WIRING DIAGRAM

removed.

FIREBRICK AND BAFFLE REPLACEMENT

BAFFLE/BRICK REPLACEMENT

If bafﬂ e replacement is necessary, slide the bafﬂ e out un-

til you can access the nuts thru the ﬂ ue outlet. Once the

nuts have been removed, slide the bafﬂ e off the rod and

thru the opening in the ﬁ rebrick. You may have to remove

one of the ﬁ rebrick to make bafﬂ e removal easier.

There are 4 full brick and 1 half brick in the top of the

furnace. Install the brick by inserting one end of the brick

angled upward and then allowing the opposite end to rest

on the ﬁ rebox lip. Lay the brick between the spacer and

ﬁ rebox back. Slide the bafﬂ e to the rear and let it rest on

that half brick. After installing brick #2 in the front, install

#3 and slide it under the bafﬂ e. Finally install bricks #4

and #5.

Table of Contents