Maintenance - Flymo SAMURAI 1000XT Original Instructions Manual

To fit nylon line only:
• Remember ! Your Flymo Trimmer is designed to
use only nylon line with a maximum diameter of
2mm. Use only genuine Flymo nylon line.
1. Take approximately 7 metres of line. Place the
centre of the line into the slot in the middle of the
spool (T1) enabling 3.5 metres of line to be wound
on either side of the centre section of the spool.
Always wind line in the direction of the arrows on
the top of the spool. Leave approximately 100mm
of line unwound and place into cleat as illustrated
in figure V.
2. Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
3. Then fit spool as described in 'To fit spool and
line complete', section above.
T
1
• WARNING
Disconnect from the mains electricity supply,
before attempting any maintenance or
adjustment. Cutting head continues to rotate
after the trimmer has been switched off.
Keep fingers and hands clear of the line
cutter on leading edge of guard.
Caring for your Product
1. Disconnect from the mains electricity supply.
2. Never clean your product with water, cleaning
fluids, or solvents, just remove debris with a
suitable tool, a soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head (W) and the motor
housing air vents. (X1)
4. Remove the cutting head. Using a soft brush,
remove any grass clippings from around the
cutting head shaft (Y).
W
Y
Cutting Head cont'
S
V
3.5 metres
3.5 metres

Maintenance

5. Inspect the product carefully, especially the parts
6. If your product is damaged in any way contact
•
7. Store in a cool, dry place and out of reach of
Cable Storage
1. Your mains cable can be stored on the product
2. Wind cable carefully to avoid kinking.
3. To release the cable press the button and the
4. Push cable hook fully back into position.
Hexagon Drive Tool Storage
1. Your Hexagon Drive Tool can be stored in the
X
Z1
of the cutting head.
your local approved service centre.
Never use a damaged product.
children.
as illustrated in Fig Z1.
hook will drop down (Z2).
Handle Clamp as illustrated in Fig Z3.
S1
Cleat
1