Dimplex DHW 300D Installation And Operating Instructions Manual page 30

DHW 300D - DHW 300D+
Menu block Menu item
1st drawdown
2nd drawdown
(only visible for devices with additional heat exchanger)
2nd heating device
Heater sel.
Bivalent temp.
(The setting of the 2nd heat generator or solar energy system only takes effect if the menu has been exited completely with the Esc key after the setting is made. When
the menu is called up again, the following menus appear depending on the setting)
(when 2nd is selected:)
Heater sel.
Bivalent temp.
(when Sol is selected:
s. Solar menu block)
Photovoltaics
Photov. Active
Set point PV
information
Operation state
Operating hours
SW Version
EN-10
Parameter Value
Start time
00:00 ... 23:59
End time
00:00 ... 23:59
Days Mo ... Su
Mo - Fr
Sa - Su
Mo - Su
Start time
00:00 ... 23:59
End time
00:00 ... 23:59
Days Mo ... Su
Mo - Fr
Sa - Su
Mo - Su
Off
2nd
Sol
-8 °C ... 10 °C ... 15 °C
Off
2nd
Sol
-8 °C ... 10 °C ... 15 °C
Yes
No
35 °C ... 45 °C ... 60 °C
upper heat accu.
lower heat accu.
air intake
collector temp.
act. set point
ventilation
compressor
heater
power
operating mode
operating hours
op. hours fan
op. hours compres-
sor
op. hours heater
451905.66.02 · FD 9506
Description
Sets the start time for lower
Sets the end time for lower
Sets the weekday / block of days on which the lowering of the domes-
tic hot water temperature should be activated
Sets the start time for lower
Sets the end time for lower
Sets the weekday / block of days on which the lower should be acti-
vated
Choice of additional heat source
Off: (no add. heat source)
2nd: 2nd heat generator, e.g. oil, gas or wood boiler
Sol: Thermal solar energy system
Limit temperature for the 2nd heat generator. The heat pump is
blocked below this temperature
Choice of additional heat source
Off: (no add. heat source)
2nd: 2nd heat generator, e.g. oil, gas or wood boiler
Sol: Thermal solar energy system
Limit temperature for the 2nd heat generator. The heat pump is
blocked below this temperature
Activates the photovoltaic function.
Entry of the domestic hot water setpoint, which is active when photo-
voltaic inlet is wired. The increased setpoint is also active if the air
intake temperature does not allow the heat pump to operate. In this
case, the request is processed with the electric heating element or,
where present, the 2nd heat generator.
Display of the cylinder temperature top
Display of the cylinder temperature bottom
Display of the air temperature
Display of the collector temperature (only on models with additional
heat exchanger and Sol selected as 2nd heat generator)
Displays the current domestic hot water setpoint
Shows the switching status of the fan
Shows the switching status of the compressor
Shows the switching status of the heating element
Shows the calculated power consumption of the device
Displays the current operating mode
Displays the operating hours
Shows the runtime of the fan
Shows the runtime of the compressor
Shows the runtime of the heating element
Shows the software version
www.dimplex.de