Please Read 1.2 Intended Use Immediately This device is only intended for use as specified by the manufac- turer. Any other use beyond that intended by the manufacturer is prohibited. This requires the user to abide by the manufacturers 1.1 Important Information product information.
Purpose of the Heat Basic Device Pump The basic device consists of a ready-to-use heat pump for indoor installation, complete with sheet metal casing, control panel and integrated heat pump manager. The refrigerant circuit is hermet- 2.1 Application ically sealed. It contains the Kyoto protocol approved refrigerant R134a with a GWP value of 1300.
Accessories 4.4 Thermal energy meter WMZ 4.4.1 General description 4.1 Brine Circuit Manifold The thermal energy meter (WMZ 25/32) is used for measuring The brine circuit manifold merges the individual collector loops of the quantity of thermal energy supplied. It is available as an ac- the heat source system into a single main pipe which is con- cessory.
Transport 6.2 Acoustic Emissions The heat pump operates silently due to efficient sound insulation. A lift truck is suited for transporting the unit on a level surface. To prevent noise transmission to the foundation, a suitable, Carrying straps may be used if the heat pump needs to be trans- sound dampening rubber mat should be placed underneath the ported on an uneven surface or carried up or down stairs.
7.4.1 Sensor characteristic curves Minimum heating water flow rate The minimum heating water flow rate through the heat pump must be assured in all operating states of the heating sys- Temperature in °C tem. This can be accomplished, for example, by installing either Standard NTC-2 in 14.6 11.4...
7.5 Electrical connection 7.4.2 Mounting the external temperature sensor 7.5.1 General The temperature sensor must be mounted in such a way that all weather conditions are taken into consideration and the During start-up, observe the respective national safety regula- measured value is not falsified. tions and the applicable VDE safety regulations, particularly ...
8.3 Start-up Procedure The contactors mentioned above in points 3, 4 and 5 are in- stalled in the electrical distribution system. The mains cables The heat pump is started up via the heat pump manager. for the heating elements should be dimensioned and pro- tected according to DIN VDE 0100.
Maintenance and 10 Faults / Trouble- Cleaning Shooting This heat pump is a quality product and is designed for trouble- 9.1 Maintenance free operation. In the event that a fault should occur, it will be in- dicated on the heat pump manager display. Simply consult the To prevent faults due to sediment in the heat exchangers, care Faults and Trouble-Shooting page in the operating instructions of must be taken to ensure that no impurities can enter either the...
12 Device Information Type and order code SIH 4ME SIH 6ME SIH 9ME SIH 11ME Design Degree of protection according to EN 60 529 IP 20 IP 20 IP 20 IP 20 Installation Location Indoors Indoors Indoors Indoors Performance data Operating temperature limits: 70±2...
3.4 Legend Wire jumper, must be inserted if no blocking contactor is fitted Wire jumper, must be removed if the 2nd disable contactor is used Wire jumper, must be removed if a motor protection contact is used for the primary pump Wire jumper, must be removed when a motor protection contact is used for the compressor Open wire jumpers or contacts mean: block or fault...
Module A CE mark added: 2011 EC declaration of conformity issued on: July 2011 Issue: 1 Dimplex Renewables Subject to alterations and errors. +44 (0) 845600511 A division of the GDC Group Ltd www.dimplexrenewables.co.u Millbrook House, Grange Drive Hedge End, Southampton SO30 2DF...