Table of Contents
Advertisement
MZ-E510
Power Supply Adjustment Auto Item Feed
Note :This mode is available to perform the temperature correc-
tion and power supply adjustment without entering the
manual mode.
• Setting method of power supply adjustment auto item
feed mode.
1. Set the test mode (see page 9)
[VOL --]
2. Press the . or
ment mode.
Remote commander LCD display
000
Assy**
[VOL --]
3. Press the
key, or press the
remote commander to set the temperature correction mode.
Remote commander LCD display
015
SetTmp# * *
** : Adjusted value
4. To change the initial value (hexadecimal), adjust with the
+]
[VOL --]
or
key.
Press the u key on the set or the
commander to write the adjusted value, and the item number
increases automatically.
When not writing the adjusted value, press the > key to
move to the next item.
Remote commander LCD display
741
VC1 L
** : Adjusted value
Configuration of power supply adjustment auto item feed
000Assy **
015 SetTmp 19
key
.
741 VC1 L **
key
.
742 VC1 PS **
.
key
743 VC2 Lo **
.
key
745 REG1 **
key
.
751 ChgV L **
key
.
752 ChgV H **
key
.
753 CIL **
key
.
754 CIH **
000 ADJ OK
18
key to activate the overall adjust-
[P MODE]
key on the
[VOL
key on the remote
**
[VOL -]£ key or¢
[P MODE]£ key on the remote
commander
>
key
>
key
>
key
key
>
key
>
key
>
key
>
key
>
>
key
5. Connect a digital voltmeter to the test points on the MAIN
board, and adjust the voltage with the
key. (see page 15 to 17)
Press the u key on the set or the
commander to write the adjusted value, and the item number
increases automatically.
6. When not writing the adjusted value, press the > key to
move to the next item.
The . key is available to back to the last item.
7. The following message is displayed after all power supply ad-
justments finish.
Remote commander LCD display
000
ADJ OK
8. Press the x key to return to the test mode (display check
mode).
[VOL +]
[VOL --]
or
key on the remote
Advertisement
Table of Contents
