Table of Contents
Advertisement
5. The display changes a shown below each time the
PLAY]
key on the remote commander is pressed.
• Address & Adjusted Value Display
Remote commander LCD display
011
C 6 8 S 0 1
address
item number
• Jitter Value & Adjusted Value Display
Remote commander LCD display
011
O F F J 0 1
jitter value
item number
• Block Error Value & Adjusted Value Display
Remote commander LCD display
011
0 6 3 B 0 1
block error
value
item number
• ADIP Error Value & Adjusted Value Display
Remote commander LCD display
011
0 5 9 A 0 1
ADIP error
value
item number
• Focus Drive Value & Adjusted Value Display
Remote commander LCD display
011
0 1 5 F 0 1
Focus drive
value
item number
• Item Title Display
Remote commander LCD display
011
L r e f P w 0 1
item title
item number
However in the power mode (item number 700's), only the
item is displayed.
6. Quit the manual mode, and press the
test mode (display check mode).
Overall Adjustment Mode
Mode to adjust the servo automatically in all items.
Normally, automatic adjustment is executed in this mode at the
repair.
For further information, refer to "SECTION 5 ELECTRICAL
ADJUSTMENTS" (see page 14).
[DIS-
adjusted value
adjusted value
adjusted value
adjusted value
adjusted value
adjusted value
key to return to the
x
Self-Diagnosis Result Display Mode
This set uses the self-diagnostic function system in which if an
error occurred during the playing, the mechanism control block
and the power supply control block in the microcomputer detect it
and record its cause as history in the nonvolatile memory.
By checking this history in the test mode, you can analyze a fault
and determine its location.
• Self-diagnosis result display mode setting method
1. Set the test mode (see page 9).
2. In the display check mode, pressing the
[DISPLAY]
ing the
key on the remote commander activates
the self-diagnosis result display mode where the LCD display
as shown below.
Remote commander LCD display
0XX
1 - - - -
history code
error display code
3. Then, each time the
>
key is pressed, LCD display descends
by one as shown below. Also, the LCD display ascends by one
when the
key is pressed.
.
0XX 1 * * * *
0XX N * * * *
0XX N 1 * * * *
0XX N 2 * * * *
XX
: Error code
* * * * : simple display
4. Quit the self-diagnosis result display mode, and press the
key to return to the test mode (display check mode).
MZ-E510
[GROUP]
key or press-
simple display
1
1
x
11
Advertisement
Table of Contents
