3–22 FRU Replacement
3.2.12 Option Board Replacement
The procedure for replacing an option board in the DECstation is
similar for the different options in the system.
1. Remove the system cover (Section 3.2.4).
2. Note the position of any cables connected to the option board
and disconnect them.
3. Remove the mounting screw that secures the option board to
the chassis.
4. Remove the board by pulling it up and out of the expansion
slot connector.
5. Configure the jumpers and switches on the new board to
match those on the old board.
6. Install the new board in the slot from which the old board
was removed. Make sure the board is firmly seated in the
connector(s) on the main logic board.
7. Secure the board to the chassis with the mounting screw.
8. Reconnect any cables you removed.