Page 1
V E H I C L E M O U N T I N S T R U C T I O N S Using the vehicle mount, you can attach your Monarch Sierra Sport4™ 9493 printer to a forklift or other vehicle.
Page 2
USB communications. For best results, use only Monarch® cables. Open the hinged cable door on the side of the printer by loosening the two screws with a Phillips screwdriver. Plug the DB9 connector into the DB9 serial port, or plug the type A or mini-B USB connector into the appropriate USB port.
Page 3
4 . Use the four mounting screws and lock washers to attach the vehicle mount to your vehicle. 5 . Wire the printer to your vehicle as needed. See “Electrical Specifications” for input information. Mounting screw Lock w asher...
Page 4
3 . Use the four mounting screws and lock washers to attach the vehicle mount to your vehicle. Wire the printer to your vehicle as needed. See “Electrical Specifications” for input information. Note: If you install the vehicle mount on a tabletop, you need to rotate the display.
Page 5
Make sure the printer’s battery and communication cable are installed. Insert the printer into the slots on the vehicle mount using the strap buttons as a guide. Aluminum strap button Push down firmly on the printer so it locks completely in place.
Page 6
Plug the battery charging cable into the battery socket on the back of the printer. R e a d i n g t h e L E D s Three LEDs on the vehicle mount indicate the following activity: LED Indicators...
Page 7
P r i n t i n g Refer to the printer’s documentation for information on loading supplies and printing. R e p l a c i n g t h e F u s e The vehicle mount uses a 10-amp, 125-volt fuse (order part 127983).
Page 8
50 watts max at 72 volts Input Current To determine the input current, divide the input power (watts) by the input voltage. Input Voltage Range The printer accommodates 12-72 volt systems. The input is transient protected. Operating Temperature 32-104°F (0-40°C) 0-95% humidity (non-condensing)