Connecting With A Wired Network - Sony MAP-S1 Operating Instructions Manual

For Windows 8/Windows 7
 Turn on PC.
 Click or tap the desktop on the Start
screen.
 Select the
bottom of the screen.
 Select [Sony_Wireless_Audio_Setup]
from the network list.
For Windows Vista
 Turn on PC.
 Click the
icon on the bottom of
the screen.
 Select [Connect to a network].
 Select [Sony_Wireless_Audio_Setup]
from the network list.
For Mac OS X
 Turn on Mac.
 Select the
screen.
 Select [Sony_Wireless_Audio_Setup]
from the network list.
4
Access the [Sony Network Device
Setting] screen.
For PC
Start the browser and input either of
the following URLs into the browser's
address bar.
http://192.168.100.1
For Mac
Start Safari and select [Bonjour] under
([Bookmarks]), then select
[SONY:MAP-S1].
5
Select the desired language
when the [Language Setup]
screen appears.
6
Select [Network Settings] from
the menu.
Network Settings
or icon on the
icon on the top of the
7
Select the SSID of the wireless
LAN router/access point, then
select [Apply].
If necessary, input the security key.
SSID
When the confirmation screen displays,
press [OK].
8 Press / to turn off the power,
then press / again to turn on
the power.
9
Connect the Mac or PC to the
wireless LAN router/access point
to be used.
Note
 This procedure needs to be completed within 10
minutes. If you cannot complete, reset your
computer (page 40).
Connecting with a wired
network
Usually, the DHCP setting is set to ON when
you connect your computer to the network.
For details, refer to the manual of your
computer.
1
Check whether your computer
and router are turned on.
2
Connect the system and the
router using a network (LAN)
cable (not supplied).
25 GB