Table of Contents
Advertisement
Getting started
Telephone base installation
1.
Plug the small end of
the larger power adapter
into the power jack at
the bottom of the tele-
phone base.
5.
Plug the other end
of the telephone line
cord into a telephone
jack.
see number four in the
note section, below.)
NOTES:
1. Use only the power adapter supplied with this product or equivalent.
ment power adapter, visit our website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
Telephone line cord
2.
Plug one end of the
telephone line cord into
the telephone jack at the
bottom of the telephone
base.
3.
slots.
4.
Plug the large end of
the larger power adapter
into an electrical outlet
not controlled by a wall
switch.
To order a replace-
Advertisement
Table of Contents
