Product Delivery - Viessmann VITOROND 100 Installation And Service Instructions Manual

Product Delivery

Fig. 1
Unpacking Instructions
To avoid injury and to facilitate boiler manoeuvering, it is strongly recommended that Viessmann carrying handles
(Part No. 7189 602) be used. The carrying handles allow easy removal of boiler from skid and enables easy transportation to
permanent location, while reducing the risk of boiler panel damage due to improper lifting or manoeuvering techniques. The
carrying handles are designed to prevent boiler slippage onto hands when carrying up/down inclines.
Legend
Casting
1" pipe, x2
Rear wooden block
Front wooden block
Fig. 2
Fig. 3
Vitorond boilers size VR1-40 to VR1-63 are shipped in a crate with separate boiler
jacketry.
CAUTION
Do not lift or position boiler alone.
Do not lift by or push against panels.
Do not bump boiler panels against
floor.
Do not drop boiler.
CAUTION
To avoid injury to hands, place
wooden block under pipes in front of
skid.
Product delivery
Ensure each of the following has been
delivered:
H Crate with boiler casting
H Crate with insulation jacket
H Carton with burner (shipped
separately)
H Carton with standard installation
equipment
If carrying handles are not available,
follow the steps below.
1. Remove top and sides of crate.
To avoid damage during lifting,
carefully remove front panel by lifting
panel up and out.
2. Place wooden block 12" from rear of
skid.
3. Insert 1" Ø Schedule 40 pipes
through openings in casting legs.
Ends of pipes should be centered on
wooden block behind skid (Fig. 2).
4. Lift boiler using pipes until clear from
skid. Remove skid from beneath
boiler (Fig. 3).
5. Lower boiler until pipes rest on front
block.
6. To remove rear block, lift (by casting
- not jacket) to tilt unit forward.
To remove front block, lift (by
casting - not jacket) to tilt unit
backward.
7. Remove pipes. Reinstall front boiler
panel once boiler is in final position.
Set-up
13