Table of Contents
Advertisement
Wall Installation
1
Reverse the handset tab as shown below.
2
Set the Tone/Pulse switch. If you have touch tone service, set
the switch to TT. If you have dial pulse (rotary) service, set the
switch to DP.
3
Connect the line cord to the
telephone.
Plug the line cord into the jack under
the phone and run the cord through
the channel as shown.
4
Connect the line cord to a modular telephone jack and
mount the phone on the wall jack as shown.
Make sure the cord snaps firmly into place. Place the phone on the
wall jack mounting studs and pull down until it is held securely.
5
Follow Steps 4 and 5 in "Table/Desk Installation" on page 3.
¥
NOTE: It is important to lift and replace the handset at least once
after installation is complete BEFORE using the speakerphone. If you
disconnect the phone for longer than 15 minutes, you must lift and replace
the handset once before using the speakerphone.
4
Modular
telephone
jack
Line cord
Advertisement
Table of Contents
