Table of Contents
Advertisement
INSTALLATION
Table/Desk Installation
1
Set the Tone/Pulse switch. If you have touch tone service, set
the switch to TT. If you have dial pulse (rotary) service, set the
switch to DP.
2
Connect the line cord to the telephone.
Plug the line cord into the jack under the phone and run the cord
through the channel as shown.
3
Connect the line cord to a modular telephone jack.
4
Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side of the phone.
Plug the other end of the coiled cord into the handset, then hang up.
5
Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial
tone, see IN CASE OF DIFFICULTY beginning on page 14.
¥
NOTE: It is important to lift the handset, listen for the dial tone, then
hang up at least once after installation is complete BEFORE using the
speakerphone. If you disconnect the phone for longer than 15 minutes,
you must lift the handset, listen for the dial tone, then hang up once before
using the speakerphone.
Line cord
Modular
telephone
jack
Tone/Pulse switch
3
Advertisement
Table of Contents
