Wiring Connection - JVC KD-X220 Instruction Manual

Wiring connection

Remote wire (not supplied)
To blue/white wire of the
wiring harness (D)
JVC Amplifier *
To the steering wheel
remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the
supplied power cord (D) as illustrated.
If the unit does not turn on with modified
wiring 1, use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Signal cord (not supplied)
1
Fuse (10 A)
Light blue/yellow
STEERING
WHEEL
REMOTE
If your car does NOT have an
ISO terminal
IMPORTANT: A custom wiring harness
(separately purchased) which is suitable for
your car is recommended for connection.
* 2
Custom wiring harness (separately
purchased)
* 3
You can also connect a subwoofer speaker
directly without an external subwoofer
amplifier. For setting, 11.
* 1
Firmly connect the ground wire of the amplifier
to the car's chassis to avoid damaging the unit.
Rear/subwoofer output
Aerial terminal
ISO connector
Pin Color and function
A2 Brown : Mobile phone system
A4 Yellow : Battery
A5 Blue/White : Power control
A6 Orange/white : Car light control switch
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple
ª
: Rear speaker (right)
B2 Purple/black
·
B3 Gray
ª
: Front speaker (right)
B4 Gray/black
·
B5 White
ª
: Front speaker (left)
B6 White/black
·
B7 Green
ª
: Rear speaker (left) *
B8 Green/black
·
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
3
ENGLISH
17