Wireless Security Screen; No Security - ZyXEL Communications WAP3205 v2 User Manual

Table 31 Network > Wireless LAN > General
LABEL
Enable Guest
WLAN
Channel
Selection
Auto Channel
Selection
Operating
Channel
Apply
Cancel

10.5 Wireless Security Screen

Use this screen to select the wireless security mode for each SSID. Click Network > Wireless LAN
> Security to open the Security screen. The screen varies depending on what you select in the
Security Mode field.

10.5.1 No Security

Select No Security to allow wireless clients to communicate with the access points without any
data encryption.
Note: If you do not enable any wireless security on your WAP3205 v2, your network is
accessible to any wireless networking device that is within range.
Figure 57 Network > Wireless LAN > Security: No Security
The following table describes the labels in this screen.
Table 32 Network > Wireless LAN > Security: No Security
LABEL
SSID
Security Mode
Chapter 10 Wireless LAN
DESCRIPTION
Select this to forward any traffic from clients that connect to this SSID to the first LAN port
on the WAP3205 v2. Clients that connect to this SSID will not be able to access the
WAP3205 v2's second LAN port.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the
frequency band and the country you are in.
This option is only available if Auto Channel Selection is disabled.
Select the check box to have the WAP3205 v2 automatically scan for and select a channel
which is not used by another device.
This displays the channel the WAP3205 v2 is currently using.
Click Apply to save your changes back to the WAP3205 v2.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select the SSID for which you want to configure the security.
Choose No Security from the drop-down list box.
WAP3205 v2 User's Guide
81