Beep - Keypad Beep; Tot - Transmission Time-Out-Timer; Dcs - Receiver Dcs; Ctcs - Receiver Ctcss - Baofeng UV-5R Documentation

8 BEEP - Keypad Beep

It should be noted that this radio does not possess a dual VFO, meaning that the Dual
Watch feature is a time sharing operation. Your radio will flip-flop between A and B
channels at a fixed rate. This will not allow you to receive two frequencies in paralell.
8 BEEP - Keypad Beep
When enabled your radio will emit an audible tone at every key press.
Key
1
0

9 TOT - Transmission Time-out-Timer

Transmission times out after set time. Radio will alert you when your time is up.
Values (seconds)
15 - 600
To use the numeric keypad for input, use the following formula: (T-15)/15 = X,
where T is the time in seconds that you want and X is a two digit code on your keypad.
Example: To get 300 seconds, take (300-15)/15 to get 19
.
10 R-DCS - Receiver DCS
Digital-Coded Squelch(DCS) will block out any signal that isn't sent with a matching
DCS code.
Setting menu
10>OFF sets
Values
menu 11=OFF
D023N - D754I
OFF
Setting menu
11>OFF sets
See Table C.1, "DCS Codes" for a complete reference of DCS codes and their corre-
menu 10=OFF
sponding numerical value. Remember to input any leading zeros when using the numer-
ical keypad. To set it to off, enter code 000.
11 R-CTCS - Receiver CTCSS
Continuous Tone-Coded Squelch System(CTCSS) will block out any signal that isn't
sent with a matching CTCSS sub-tone.
Appendix B. Menu definitions
Values Notes
ON
OFF
Notes
Increments of 15 seconds
Notes
Baofeng UV-5R
Default value
ON
Default value
60
Default value
OFF
51
The Red TX LED
begins to flash 10
seconds before
timeout occurs