Baofeng UV-5R Documentation page 45

Radio to radio cloning
2. Turn on the slave radio, (the radio you want to clone to).
3. Turn on the master radio, (the radio you want to clone from) while holding down
the
The master will show COPING in the display, and if makes a successful connection
to the slave it will start flashing red to indicate it's transmitting data. The slave will
at that same time flash green to indicate it's receiving data.
4. When LEDs turn off, the radio's will restart and the cloning operation is completed.
A word of caution when cloning
It should be OK to clone between a UV-5R master and slave with any firmware
version from BFB230 to BFB290.
Cloning may fail between a UV-5R master or slave that has a firmware version
from BFB291 and newer.
Chapter 10. Programming
key.
Baofeng UV-5R
37