Illumination Settings - Pioneer DEH-X8750BT Owner's Manual

Menu Item
Auto PI
[ON], [OFF]
Warning tone
[ON], [OFF]
AUX
[ON], [OFF]
BT AUDIO
[ON], [OFF]
PANDORA
[ON], [OFF]
Clear memory
[Clear memory YES], [Cancel]
BT Version Info.
APP CONNECT MODE*1
[Wired], [Bluetooth]
Steering ctrl set.*2
[OFF], [Pioneer], [Preset]
*1 Not available when [Pandora] or [App] is selected as the source.
*2 Depending on your car, this function may not work properly. In this case, contact your dealer or an
authorized PIONEER Service Station.
16
En
Description
Search for a different station with the same
programming, even if using a preset station.
A beep can be heard when the front panel is not
detached from the head unit within four seconds
of turning off the ignition. Select [OFF] to disable
this function.
Set to [ON] when using an auxiliary device
connected to the unit.
Set the Bluetooth signal on/off.
Set to [ON] when using the Pandora function.
Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[Cleared] appears when data is successfully
deleted.
Displays the system version of the unit and the
Bluetooth module.
Select the appropriate connection method
according to your device.
Select [Pioneer] or [Preset] according to your
wired remote control.

ILLUMINATION settings

Menu Item
Color Setting
[Key Side], [Display Side], [Key &
Display]
Dimmer Setting
[Sync Vehicle Illumi], [Sync Clock],
[ON], [OFF]
Brightness
[1] to [10]
Phone Color
[Flashing]
[Flash FX 1] to [Flash FX 6]
[OFF]
Illumi Effect
[ON], [OFF]
Description
Select color for the keys/display of the unit from
12 preset colors, [Scan] or [Custom]*.
• [Scan]: Cycle through a variety of colors
automatically.
• [Custom]*:
1 Press and hold the M.C. dial until the color
setting display appears.
2 Set the primary color (R (red)/G (green)/B
(blue)) and brightness level ([0] to [60]).
You cannot select a level below 20 for all three
of R (red), G (green), B (blue) at the same time.
You can also customize the preset colors. Select
one of the preset colors, then press and hold the
M.C. dial until the color setting display appears.
* The Custom setting is only available for [Key Side]
and [Display Side].
Change the display brightness.
Change the display brightness.
The available setting ranges differ depending on
[Dimmer Setting].
Select the key color when a call is received.
Applies the color set by [Key Side].
Cycle through a variety of colors automatically.
No change in key color made.
The illumination effect can be seen when;
– there is an incoming call
– you are on the phone
– a CD is inserted/ejected