Belkin F1DN102F-3 User Manual page 23

TroublesHooTInG
SECTIONS
Table of Contents
no video image appears on user display in one channel
• Reboot the computer
• Check that the video cable connecting computer and KVM is
properly secured at both sides
• Check that PC video output is sent to the connected video
connector if PC supports multiple displays
• Check that PC resolution matches connected display capabilities
• Connect the display directly to the PC to confirm that video output
is available and that good image is shown
bad video image quality one or both channels
• Check that all video cables are properly connected to the Switch,
computer, and display
• With everything connected, power-cycle the Belkin Secure Flip
KVM Switch to reset the video. Make sure the Video Diagnostic
LED is solid green
• Check that the display that you are using supports the resolution
and refresh-rate settings on your computer
• Lower the video resolution of your PCs
• Connect the display directly to the computer you are having
trouble with to see if the problem still appears
note: If the Belkin Secure Switch does not work properly, or the
configuration procedure is unclear or does not work, contact Belkin
support at 1-800-282-2355.
Belkin Advanced Secure 2-port Flip KVM Switch User Manual
1 2
21
3 4 5 6