Table of Contents
Advertisement
Preparing Power Supply
Always make sure to turn off the camera's power status before changing power
supply.
Important
The cease of power supply will cause all the images to be lost. When battery power level
is low, battery icon will blink. Connect to PC and save pictures immediately, or the
pictures may be lost due to the cease of power supply.
Back up time to store the recorded images/videos during batteries replacement is about 1
minute.
Loading Batteries
To load the batteries into the camera:
1. Slide the battery door open in the direction indicated by the arrow.
2. Insert AAA batteries (2 units) with polarity as shown on the diagram inside the
battery compartment.
3. Close the battery door.
Note
If you are not going to be using the camera for an extended period of time, you
should remove the batteries to prevent leaks or corrosion.
Do not use a mix of different types, manufactures, classification of batteries.
Low temperatures (under 0
shortening the operation time of camera.
EN-8
O
) may reduce the output efficiency of batteries, thereby
Hide quick links:
Advertisement
Table of Contents
