Connect-Sequence Attempts; Connect-Sequence Interface-Recovery; Connect-Mode Originate; Ip Address Negotiated - ADTRAN 3G CDMA NIM Configuration Manual

3G CDMA NIM/Cellular Interface
Table 4. Demand Routing Interface Configuration Commands (Continued)
Prompt
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
(config-demand 1)#
61700801G1-29.1H
Command
connect-sequence <value>
dial-string <string>
forced-cellular

connect-sequence attempts

<value>
connect-sequence
interface-recovery
connect-mode [answer |
originate | either]

ip address negotiated

no shutdown
ip access-policy <name>
idle-timeout <value>
description <text>
Copyright © 2010 ADTRAN, Inc.
Configuration Command Summaries
Description
Specifies the connection method
the demand interface will use
when connecting to the cellular
network. For cellular
connections, the dial string must
be #777.
Specifies the number of times
the demand interface will
attempt to connect to the cellular
network. Range is 0 to 65535.
Zero indicates unlimited
attempts will be made and
should be used for cellular
applications.
Specifies the interface will go
down if attempted connections
to the cellular network fail.
Specifies that the demand
interface will answer or originate
calls, or both. For cellular
connections, the demand
routing interface should be set
to originate.
Specifies that the demand
interface will be assigned an IP
address from the far end PPP
connection.
Specifies that the interface is
enabled.
Assigns an access policy to the
demand interface.If you are
using AOS firmware prior to
17.09.00, this command syntax
is access-policy <name>.
Specifies the amount of time
before the demand routing
interface times out if no
interesting traffic is detected.
Range is 1 to 2147483 seconds.
Creates a descriptive name to
identify the interface (up to 80
alphanumeric characters).
43