Print Settings - Canon MX920 Series Online Manual

Print settings

• Prevent paper abrasion
Use this setting only if the print surface becomes smudged.
Important
Be sure to set this back to OFF after printing since it may result in lower printing speed or lower
print quality.
• Extended copy amount
Selects the amount of image that extends off the paper when printing in borderless (full).
Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You
can change the width to be cropped from the borders of the original image as needed.
Cropped area will be larger if Extended amount: Large is selected.
Important
This setting can be applied under the following conditions:
- performing borderless copying
- Borderless is selected for Border when copying printed photos
Note
If printouts contain margins even though you are printing in Borderless, specifying Extended
amount: Large for this setting may help solve the problem.
• Adjust disc print area
You can adjust the disc printing area if the image is not aligned with the printable disc.
You can adjust the printing area by 0.003 inches/0.1 mm between -0.03 inches/-0.9 mm and +0.03
inches/+0.9 mm.
• Auto photo fix setting
When ON is selected, you can select whether to print photos using the Exif information recorded in the
image files in the following cases.
• Auto photo fix is selected for Photo fix when printing from a USB flash drive.
• When Auto photo fix is selected for Photo fix in printing a photo in online photo album.
• The print setting on the PictBridge compliant device is set to Default* or On when printing with a
PictBridge compliant device.
* When Default is selected for the print setting on the PictBridge compliant device, select Auto
photo fix for Photo fix in PictBridge print settings.