Table of Contents
Advertisement
Appendix
Troubleshooting
Incomplete
• If a caller leaves a very long message, part of it may be lost when the
messages.
• If the caller pauses for more than 7 seconds, the system stops
• If the system's memory becomes full during a message, the system
• If the the caller's voice is very soft, the system may stop recording
• Press VOLUME
Difficulty hear-
ing messages.
• Remove any stickers that may have come on your telephone
System does
• Make sure that the answering system is on (see page 27).
not answer
• If Toll Saver is activated, the number of rings changes to 2 when you
after correct
number of
• In some cases, the system may be affected by the ringing system
rings.
• If the memory is full or the system is off, the system will answer after
• You need to reset the answering system clock (see page 28).
"CL" flashes
in message
window.
System does
• Make sure to enter your remote access code correctly (see page 35).
not respond
• Make sure you are calling from a touch-tone phone. When you dial a
to remote
commands.
• The answering system may not detect the remote access code while
• There may be noise or interference on the phone line you are using.
System does
• Make sure answering system is on (see page 27).
not record
• Make sure Announcement Only is off (see page 30).
message.
Announcement
• When you record your announcement, make sure you speak in a
message is not
clear.
• Make sure there is no background noise (TV, music, etc.) while you
system disconnects the call after 4 minutes.
recording and disconnects the call.
stops recording and disconnects the call.
and disconnects the call.
^
to increase speaker volume.
base and/or handset when you purchased it, they may be
obstructing your messages when you play them.
have new messages waiting (see page 31).
used by the local telephone company.
10 rings.
number, you should hear tones. If you hear clicks, the phone is not a
touch-tone telephone and cannot activate the answering system.
your announcement is playing. Try waiting until the announcement is
over before entering the code.
Press dial-pad buttons firmly.
normal tone of voice, about 9 inches from the base.
are recording.
43
Advertisement
Table of Contents
