❷ Connecting Your Computer/Connecting The Power Cord - Dukane 6230WA User Manual

❷ Connecting Your Computer/Connecting the Power Cord
1. Connect your computer to the projector.
This section will show you a basic connection to a computer. For information about other connections, see "6.
Installation and Connections" on page 122.
Connect the computer cable (VGA) between the projector's COMPUTER IN terminal and the computer's port (mini
D-Sub 15 Pin). Turn two thumb screws of both terminals to fix the computer cable (VGA).
2. Connect the supplied power cord to the projector.
First connect the supplied power cord's three-pin plug to the AC IN terminal of the projector, and then connect the
other plug of the supplied power cord in the wall outlet.
The projector's power indicator will light red* (standby mode).
See the Power Indicator section.(→ page 136)
To wall outlet
Make sure that the prongs are fully inserted into
both the AC IN terminal and the wall outlet.
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if the
AC power supply is disconnected during normal projector operation.
Use caution when picking up the projector.
COMPUTER IN
14
2. Projecting an Image (Basic Operation)