Table of Contents
Advertisement
❷ Connecting Your Computer/Connecting the Power Cord
1. Connect your computer to the projector.
This section will show you a basic connection to a computer. For information about other connections, see "(2)
Making Connections" on page 145.
Connect the display output terminal (mini D-sub 15 pin) on the computer to the COMPUTER IN terminal on the
projector with a commercially-available computer cable (with ferrite core) and then turn the knobs of the terminals
to secure them.
2. Connect the supplied power cord to the projector.
WARNING
MAKE SURE TO TAKE THE GROUND CONNECTION FOR THE DEVICE.
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
DO NOT USE THIS UNIT'S PLUG WITH AN EXTENSION CORD OR IN AN OUTLET UNLESS ALL THE
PRONGS CAN BE FULLY INSERTED.
Important Information:
• When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed
to the off [O] position. Failure to do so may cause damage to the projector.
• Do not use a three-phase power supply. Doing so may cause of malfunction.
First connect the supplied power cord's three-pin plug to the AC IN terminal of the projector, and then connect
the other plug of the supplied power cord in the wall outlet.
COMPUTER IN
Computer cable (with ferrite core)
(sold commercially)
14
2. Projecting an Image (Basic Operation)
Make sure that the prongs are fully inserted into
both the AC IN terminal and the wall outlet.
To wall outlet
Advertisement
Table of Contents
