The External Monitor Is Blank Or The Image Is Unstable; The Notebook Stops Working; The Mouse Does Not Work - Fujitsu Siemens Computers LITELINE Series Operating Manual

The external monitor is blank or the image is unstable

The wrong external monitor has been selected or the wrong screen resolution has been set for the
application program.
Ê
Terminate the application program in Windows 9x with [Alt]
occur after ending the program, switch over to the internal LCD display with [Fn]
carry out the following routine:
Ê
Select the correct monitor or set the correct screen resolution.
−
Setting the screen resolution: Select Start - Settings- Control Panel - Display - Settings and
then the screen resolution you require in the Resolution field.
−
Selecting the monitor: Select the correct monitor under Start - Settings- Control Panel -
Display - Settings - Advanced Properties - Monitor - Modify .

The notebook stops working

If the notebook stops working, this may have the following reasons:
The notebook is in Standby or Suspend mode
Ê
Reactivate the notebook by pressing a key (Standby mode) or by switching it back on
(Suspend mode).
An application program has caused the malfunction
Ê
Close the application program or restart the notebook by switching it on/off or with a warm
boot.
The battery is dead
Ê
Charge the battery.
or
Ê
Install a charged battery.
or
Ê
Connect the power adapter to the notebook.

The mouse does not work

If the connected mouse does not work, the following can cause it:
Mouse driver not loaded
Ê
Check whether the correct mouse driver is properly installed and is present before the
application program is started. Detailed information can be found in the User Guides for the
mouse or application program.
A26391-K96-Z100-2-7619
Troubleshooting and tips
[F4]. . . . If the fault continues to
[Alt] + [F4]
[Alt] [Alt] [F4] [F4]
[Fn] + [F12] [Fn] [Fn] [F12] and [F12] [F12]
41