Optical Drive - HP ProLiant DL360e Gen8 Maintenance And Service Manual

Remove the optical drive blank
Retain the blank for future use.
To replace the component, reverse the removal procedure.

Optical drive

CAUTION:
all bays are populated with a component or a blank.
To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 31).
o
Remove the access panel
4.
Remove the optical drive:
5.
To prevent improper cooling and thermal damage, do not operate the chassis unless
("Access panel" on page 35).
Removal and replacement procedures 36