Removing A Hot-Plug Fan Blank Or Module If The Server Is Installed In A Friction Rail System - HP ProLiant DL360e Gen8 Maintenance And Service Manual

Do one of the following:
4.
Remove the fan blank.
o
Remove the fan module.
o
To replace the component, reverse the removal procedure.
If the fan replacement is intended to upgrade the server from a nonredundant to a redundant fan mode,
reboot the server after fan installation.
Removing a hot-plug fan blank or module if the server is installed
in a friction rail system
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Removal and replacement procedures 41