IBM xSeries 360 Type 8686 Installation Manual page 26

Microprocessor
connector 4 (U22)
Microprocessor 4
VRM connector
(J29)
Microprocessor 2
VRM connector
(J30)
Microprocessor
connector 2 (U23)
Complete the following steps to install a microprocessor:
1. Review the safety precautions beginning on page v and "Handling static-sensitive
2. Turn off the server, disconnect all power cords and external cables, and remove
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, see "Handling static-sensitive devices" on page 3.
3. Lift off the microprocessor heat sink stabilizer as shown in the following illustration
16
IBM xSeries 360 Type 8686:Installation Guide
devices" on page 3.
the top cover (see "Removing the server top cover and bezel" on page 7).
and determine the socket where the microprocessor is to be installed.
Microprocessor
connector 1 (U11)
Microprocessor 1
VRM connector
(J2)
Microprocessor 3
VRM connector
(J3)
Microprocessor
connector 3 (U12)