IBM xSeries 360 Type 8686 Installation Manual page 21

SCSI RAID
cable connector
b. Route the cable along the surface of the system board toward the front of the
server, then to the right under the adapters and dividers; then plug it into the
SCSI RAID cable connector (J43) on the system board.
Notes:
1) You cannot install a full-length, wide adapter in PCI-X slot 1 if the SCSI
RAID adapter cable connector is in use.
2) You might need to remove adapters or plastic dividers to access the SCSI
RAID adapter cable connector.
3) The first time that you restart the server after connecting the cable, the
server issues POST error message 00180700 with modifier 9005008F;
this message is normal. It indicates that the onboard SCSI controller has
been disabled and that the RAID adapter is controlling the internal hard
disk drives.
9. If you are installing a ServeRAID adapter and plan to use external hard disk
drives:
a. Plug in one end of the ServeRAID external channel cable (separately order-
able) to an external channel connector on the edge of the ServeRAID adapter
that is accessible from the rear of the server.
b. Route the cable to the external SCSI device and plug it into the appropriate
connector.
10. Install the latest ServeRAID drivers, using the ServerGuide
11. Configure ServeRAID, using the ServeRAID adapter documentation on the
xSeries 360 Documentation CD.
12. If you have other options to install or remove, do so now; otherwise, go to "Com-
pleting the installation" on page 19.
ServeRAID adapter
™
™ CDs.
Chapter 2. Installing options
11